[uClinux-dev] Building uClinux kernel (2.6.19) for S3C4510b from scratch.

[Greg Ungerer]

Hi Surej,

Surej Antony Joseph wrote:
>   I'm new to this mailing-list. I'm trying to build uclinux kernel for 
> ARM S3C4510B. I downloaded the 2.6.19 stock kernel and patched it with 
> linux-2.6.19-uc0-big.patch.gz. I'm using the latest version of uClinux 
> ARM compiler from CodeSourcery. Here are the command's i used:
> 
> make ARCH=arm CROSS_COMPILE=arm-uclinuxeabi- V=1 espd_4510b_defconfig.
> 
> After this:
> 
> make ARCH=arm CROSS_COMPILE=arm-uclinuxeabi V=1 2>&1 | tee build.log
> 
> I faced numerous compilation issues( i fixed the compilation issues but 
> not sure if its working) and linking issues. I would like to know if its 
> possible to build the kernel alone in this way. If yes, am i missing 
> some steps here?

ARM non-mmu support is still in a state of flux in 2.6.x kernels.
What compile problems did you hit?

Regards
Greg



> Here I'm trying to learn how to build each 
> component(kernel,uClibc,Busybox) from scratch.
> 
> Thanks for your support.
> 
> Thanks,
> Surej Joseph.
> _______________________________________________
> uClinux-dev mailing list
> uClinux-dev at uclinux.org
> http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
> This message was resent by uclinux-dev at uclinux.org
> To unsubscribe see:
> http://mailman.uclinux.org/mailman/options/uclinux-dev
> 

-- 
------------------------------------------------------------------------
Greg Ungerer  --  Chief Software Dude       EMAIL:     gerg at snapgear.com
Secure Computing Corporation                PHONE:       +61 7 3435 2888
825 Stanley St,                             FAX:         +61 7 3891 3630
Woolloongabba, QLD, 4102, Australia         WEB: http://www.SnapGear.com