[uClinux-dev] ARM Kits with sound support from uClinux

[Josue de Freitas]

Thanks all that answer.


Best Regards, Josue.

On 11/13/07, Robin Getz <rgetz at blackfin.uclinux.org> wrote:
> On Thu 8 Nov 2007 06:46, Josue de Freitas pondered:
> > Hi,
> >
> > We're beginning a project that deal with audio input/output and network and
> > we're looking for ARM Development Kits that have sound support on uClinux
> > (any kernel) and also Ethernet interface.
> >
> > Any tip are very welcome. Thanks in advance.
>
> It's not an ARM, but Linux has recently been ported to the BF527 - which
> includes both a stereo CODEC, and Ethernet MAC in the 12x12mm mini-BGA.
>
> http://www.analog.com/en/epProd/0,,ADSP-BF527C,00.html
>
> Development kits will be shipping in a few weeks.
>
> http://www.analog.com/en/epHSProd/0,,BF527-HARDWARE,00.html
>
>  * ADSP-BF527 Processor: 600MHz
>  * SDRAM: 64 MB, 32M x 16; Micron MT48LC32M16A2 3.3V
>  * NOR FLASH: 4 MB (2M x 16 ); ST Micro M29W320EB70ZE6E 3.3V
>  * NAND FLASH: 4 Gb ST Micro NAND04; NAND04GW3B2B 3.3V
>  * SPI FLASH: 16 Mb Atmel ST M25P16-VMW6G 3.3V
>  * Audio CODEC: Low power audio CODEC
>  * Power Analysis Interface: Sense resistors
>  * LCD Display: Varitronix - Landscape QVGA (/dev/fb drivers exist)
>  * Ethernet MAC: On chip 10/100 (achieves line rate with Linux driver)
>  * Ethernet PHY: SMSC (RMII); LAN8700 (uses PHY Lib in kernel)
>  * Thumbwheel: Rotary Encoder (/dev/input interface)
>  * UART: DB9 female connector
>  * RTC Battery: 3.0 Volt Li-ION
>  * LEDs: 13 LEDs: 1 power (green), 1 board reset (red),
>          8 general purpose (amber), 2 Ethernet (amber)
>  * Push Buttons: 3 push buttons w/ debounce logic: 1 reset,
>          2 programmable flag
>
> -Robin
>


-- 
"All of us get lost in the darkness. Dreamers learn to steer by the
stars" - Rush, The Pass.