[uClinux-dev] ARM Kits with sound support from uClinux

[Robin Getz]

On Thu 8 Nov 2007 06:46, Josue de Freitas pondered:
> Hi,
> 
> We're beginning a project that deal with audio input/output and network and
> we're looking for ARM Development Kits that have sound support on uClinux
> (any kernel) and also Ethernet interface.  
> 
> Any tip are very welcome. Thanks in advance. 

It's not an ARM, but Linux has recently been ported to the BF527 - which 
includes both a stereo CODEC, and Ethernet MAC in the 12x12mm mini-BGA.

http://www.analog.com/en/epProd/0,,ADSP-BF527C,00.html

Development kits will be shipping in a few weeks.

http://www.analog.com/en/epHSProd/0,,BF527-HARDWARE,00.html

 * ADSP-BF527 Processor: 600MHz
 * SDRAM: 64 MB, 32M x 16; Micron MT48LC32M16A2 3.3V
 * NOR FLASH: 4 MB (2M x 16 ); ST Micro M29W320EB70ZE6E 3.3V
 * NAND FLASH: 4 Gb ST Micro NAND04; NAND04GW3B2B 3.3V
 * SPI FLASH: 16 Mb Atmel ST M25P16-VMW6G 3.3V
 * Audio CODEC: Low power audio CODEC
 * Power Analysis Interface: Sense resistors
 * LCD Display: Varitronix - Landscape QVGA (/dev/fb drivers exist)
 * Ethernet MAC: On chip 10/100 (achieves line rate with Linux driver)
 * Ethernet PHY: SMSC (RMII); LAN8700 (uses PHY Lib in kernel)
 * Thumbwheel: Rotary Encoder (/dev/input interface)
 * UART: DB9 female connector
 * RTC Battery: 3.0 Volt Li-ION
 * LEDs: 13 LEDs: 1 power (green), 1 board reset (red), 
         8 general purpose (amber), 2 Ethernet (amber)
 * Push Buttons: 3 push buttons w/ debounce logic: 1 reset, 
         2 programmable flag

-Robin