[uClinux-dev] Serial support with kernel 2.6

[Brandon Fosdick]

David Wu wrote:
> OK now. I have figured out the problem. Port UA Pin Assignment Register 
> should set to UART mode.

I ran into the same type of problem using the 8250 driver on an LPC2294. 
Is there some hook for doing hardware specific setup for a generic 
driver like the 8250? For now I'm using the early-console hooks just to 
do the pin config, but that's an ugly hack.

______________________________________________________________________
This email has been scanned by the MessageLabs Email Security System.
For more information please visit http://www.messagelabs.com/email 
______________________________________________________________________