[uClinux-dev] FW: 5275 Colilo Code Help
kapheine at gmail.com
Fri Aug 19 14:00:52 EDT 2005
> I believe that the PLL, chip selects, and DDR is set up correctly and
> does run through this part of the code however I can't get the serial
> ports to work much less boot Linux.
> All help is greatly appreciated.
Do you know how far your code is getting? If you have BDM setup, you
might want to use
that. Otherwise, light up an LED or toggle a GPIO pin to determine
how far your code is
getting. That should help you determine what block of code is faulty.
Zachary P. Landau <kapheine at gmail.com>
More information about the uClinux-dev