[uClinux-dev] How do I move the console from ttyS0 to ttyS1 o n a Coldfire 5272?
Van Rafelghem, Dominique
VanRafelghemD at intheairnet.com
Fri Mar 28 21:10:13 EST 2003
I am using the latest uClinux-20030305 distribution and there is no such
setting under the "Processor type and features". Perhaps it has moved.
Does anyone out there now where I might find this in this distribution?
From: Michael Caisse [mailto:mcaisse at allweatherinc.com]
Sent: Friday, March 28, 2003 4:59 PM
To: uclinux-dev at uclinux.org
Subject: Re: [uClinux-dev] How do I move the console from ttyS0 to ttyS1
on a Coldfire 5272?
I use make xconfig, but you can find the same in make config...
With make xconfig....
Under "Target Platform Selection", select 'yes' for Customize Kernel
At the Main Menu, select "Save and Exit".
Selecting "Processor type and features" will get you to a configuration
parameter about Compiled-in Kernel Boot Parameter (CONFIG_BOOTPARAM_STRING).
Select yes and then provide the kernel boot parameter. For example,
the one I'm using is:
You should be able to:
or whatever fits your fancey.
Van Rafelghem, Dominique wrote:
> I am running uClinux on a custom board design which is based on
> Motorola's 5272C3 reference design and I need to move the serial
> console over onto ttyS1 instead of ttyS0. I'm using the 2.4.x kernel.
> I've searched the archives and all the advice I can find is either for
> the 2.0.x kernel or is very ambiguous.
> Thank you,
uClinux-dev mailing list
uClinux-dev at uclinux.org
This message was resent by uclinux-dev at uclinux.org
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the uClinux-dev