[uClinux-dev] h8 board
gerg at snapgear.com
Tue Mar 18 19:11:28 EST 2003
> you're right.
> i'm totaly new to hitachi mcu. and bad luck - there are like tons of
> same ic numbers and specs. never had the time to even settle for good
> read of one. will do later :)
Quite a good number of H8/300 devices are supported in the
uClinux 2.0.x and 2.4.x kernels. from the arch/h8300/config.in
I can see:
For sepcifics have a look at Yoshinori Sato's pages at:
> Richard Klingler wrote:
>>> i'm sorry for not specifing about using ucLinux for h8/300H hitachi
>>> i've seen some web pages about the project.
>>> h8s and h8/300h share the same core, right? 16-bit. it is possible to
>>> run uclinux on those. further, h8/tiny is somekind of "enhanced" - as
>>> stated in their docs - h8/300h. thus running uclinux on it shouldn't
>>> be a problem...
>> Please read the datasheet next time (o;
>> This LSI has an H8/300H CPU with an internal 32-bit architecture that
>> is upward-compatible with the H8/300CPU, and supports only normal
>> mode, which has a 64-kbyte address space.
>> Never saw any uClinux which could fit onto 64kbytes...(o;
>> As told before...there is no 16-bit (uC)linux version and never will.
>> Richard Klingler mail: richard.klingler at violasystems.com
>> Viola Systems Ltd. http://www.violasystems.com/
>> Lemminkäisenkatu 32 phon: +358 (0)201 226 226
>> 20520 Turku, Finland mobile: +358 (0)40 748 4711
>> uClinux-dev mailing list
>> uClinux-dev at uclinux.org
>> This message was resent by uclinux-dev at uclinux.org
> uClinux-dev mailing list
> uClinux-dev at uclinux.org
> This message was resent by uclinux-dev at uclinux.org
Greg Ungerer -- Chief Software Wizard EMAIL: gerg at snapgear.com
SnapGear Pty Ltd PHONE: +61 7 3435 2888
825 Stanley St, FAX: +61 7 3891 3630
Woolloongabba, QLD, 4102, Australia WEB: www.SnapGear.com
More information about the uClinux-dev