[uClinux-dev] compiling error's after making changes to support ATAPI

thomas chen tchen at on-go.com
Sat Mar 1 11:17:38 EST 2003


thanks... i had everything except turning on mount/nfs option

however.. now i am getting
rpc timeout error?
and
nfs: mount did not pass remote address


what could this be?


Erwin Authried wrote:
> 
> > -----Ursprungliche Nachricht-----
> > Von: uclinux-dev-admin at uclinux.org
> > [mailto:uclinux-dev-admin at uclinux.org]Im Auftrag von thomas chen
> > Gesendet: Samstag, 01. Marz 2003 05:35
> > An: uclinux-dev at uclinux.org
> > Betreff: [uClinux-dev] nfs mount question
> >
> >
> >
> > how do you mount nfs from an embedded target
> >
> > i have busybox mount
> >
> > when i did
> >
> > mount -t nfs 192.168.1.200:/home /usr
> >
> > if first complain that mount is older than the kernel?
> > and then NFS complain mount did not pass remote address?
> >
> > did i miss something
> >
> 
> On uclinux:
> - CONFIG_NFS_FS must be enabled
> - uClibc must be compiled with the RPC library support.
> - Busybox must be compiled with NFS support.
> 
> On the host:
> - CONFIG_NFSD and CONFIG_SUNRPC must be enabled. I think the *_V3 stuff must
> be disabled.
> 
> Some people said that portmap must run on uClinux. I found that it works
> without that too, you just get a few error messages when the fs is mounted.
> 
> Regards,
> Erwin
> 
> _______________________________________________
> uClinux-dev mailing list
> uClinux-dev at uclinux.org
> http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
> This message was resent by uclinux-dev at uclinux.org



More information about the uClinux-dev mailing list